Trim

[CVH]

Hi,

Something similar as in this post?

[Solved] Bulk Break out

Hello, everyone! I’m looking for a command / scripted way to apply ‘Break out segment’ to a group of lines. Here’s a helping picture. [bulkBreakout.png] What I’m trying to achieve is getting the same result as if I was applying (D, 2) to all those lines, using the vertical line as guiding intersection. I’d like to apply this to the whole group, avoiding clicking on each line. Actually, the best case would be removing everything on the left of that vertical line, but I could do that using sele…

Feature request here:

FS#1983 : Trim All or Bulk Break out

The workaround with Clip to Rectangle (CLR) only works when your limiting line is horizontal or vertical.
And there is a bug: FS#2347 : Modify / Clip to rectangle issue
‘Clip2Boundary’ would be a solution with an angled limiting line or with curved shapes.

A recent solution aka workaround is using Break out Segment (D2) in Line Selection Mode. (See Options Toolbar)

Remind that in some rare cases with some trimming tools QCAD might still return (near) zero-length results.

Regards,
CVH